The manuals equipped with the ball mill are mainly about the structure, performance and operation of the ball mill. It is believed that these knowledge can be easily mastered as long as you read the manual carefully, but there are many tips for maintaining the ball mill and the cleaning of the ball mill. Few people know about it. We will use this article to understand the problems encountered in the operation of the ball mill and the precautions for maintenance and cleaning.
In addition, there is a common sense in the common sense structure of the ball mill. This common sense is regarded as the common sense of the ball mill. This kind of common sense is usually not summed up and paid too much attention, because of its own small operation, because they are not direct Participate in the factors that affect the operation of the ball mill, so we are a negligent emotion about them. However, after a complete analysis of some faults of the ball mill, we will find that the main reason for the fault is caused by this small question. So let's make some clarifications about them. We have introduced some common sense before. The same topic we are going to introduce today is also a small common sense point of ball mill. This common sense point is about the finishing work of ball mill.
We have mentioned such a topic before, which is about the question of the lubricating oil of the ball mill. We mentioned that the purity of the lubricating oil is very important. If it is mixed with impurities and dust, the lubricating oil will not work well. The effect is greatly reduced. The smoothness of the ball mill is naturally very important, so it is urgent to remove dust and maintain the cleaning of the ball mill. There are many cleaning operations, and the effect is more than one point. Below we will arrange them and provide us with all of them.
1. Make sure the inside of the mill is clean. Sort out the debris of the ball mill mill.
2. Ensure the cleaning of the inlet and outlet of the ball mill to prevent debris in the suction pipe.
3. Make sure to check the cleaning of bearings and cylinders regularly.
4. Ensure that the ball mill coupling part and the surface of the reducer are cleaned.
5. Ensure the cleaning of the inside and surface of the motor.
Before the operation, we clean these positions of the cone ball mill, so that some doubts will be avoided during the production process, which is a relatively large assistance and adjustment to the production of our ball mill. At the same time, we hope that we can pay attention to these questions very well, because sometimes the effects of details are infinite, and small questions often determine the success or failure of the work.
